Now that we have created our user interface and our block diagram you can go to the tools maker hub
Linux and go to the Linux firmware without as you can see.
This result has an unwinnable.
You can choose the type of the Arduino board that you are using we are using our green on and tool change
shape depending on the bolt that you are using.
Again we are using arduino board.
You can choose SPARC fun or declined any or another device family.
And here you can choose different firmware upload method.
The only option is cereal or your ISP for the arguing about click next.
Now as you can see here you need to select the combo to use when uploading firmware to the Arduino board.
What you need to do here is right click and select the onboard associated with the abdominal wall.
You have to connect your Arduino then look to the device manager and go to the board section and here
you will find out what's going on on the board.
No I didn't connect one yet so there is no one I will choose comm for for the purpose of this lesson.
Now click Next as you can see firmware version Linux serial and upload type pre-built framework.
Now you are done.
Click Next as you can see it's uploading dribble dribble takes which is not something that we want to
do since we haven't yet connected our original goal in the next lesson.
I would connect our album in a vault and we will test it out using the software that we have now what
you need to do.
You can't simply launch example or click finish.
That's it for this lesson.
This is how you can configure your Arduino combos Arduino both type to match the ones that you are using
and connecting to your computer so that you can easily control them using your lab view interface.
Thanks for watching this lesson.
If you have any questions please ask index roundtable.