Hi and welcome back in this tutorial, I'm going to teach you how to perform evil twin attack an evil
twin is a rogue or fake wireless access point that appears as a genuine hotspot.
The idea is to set up your own network that looks exactly like the one you are attacking.
So let's get started.
First tip, as always, is to make sure you have your wireless adapter into monitor mode and then scan
all the wireless access points in your range using Arrow Dump Energy and the name of your interface.
Now you need to find the access point you want to clone.
Mine is clean it, so I'm going to use Airbase Energy, which is a tool used to convert your wireless
card into an access point.
So go ahead and type in the following Airbase and G Dash A and the Mac address of the access point you
want to clone.
Dash E for the name of the network and Channel six and then the Interface W line zero more.
Now the fake access point is running.
Next step is forcing the client to disconnect from the real access point and connecting to your fake
access point using the following command.
AirPlay and G Dash zero zero, Dash eight and the Mac address of the real access point.
Now, if my signal is stronger, he will automatically reconnect to my evil twin.
As you can see, a client has connected to my fake access point.
OK, so now I need to provide internet access to the fake access point.
And to do this, you just have to know which interface is providing you with internet.
Mine.
Is it age zero?
First of all, you need bridge utils.
So go ahead and type up with to get install bridge utils.
And after the installation has completed, type B or C, D, L and B are fake, you can name it any
way you like.
In my case, I have name ID fake, but it doesn't really matter.
Next, i b r c d l add e fake eta h zero.
This will create a bridge between fake and ETA age zero, which has internet access.
You also need to add the interface, which is created by Air Base and G, so use the same command.
Just change the name of the interface to eighty-year-old.
This interface should be the same on your system because air based NGO will create this interface for
you.
Next step is to add IP addresses to these interfaces and bring them up.
So go ahead and type ifconfig 8-0 up and then I f config fake op.
And finally, the evil twin attack is complete.
The client is now connected to your fake network and can use the internet.
Now, all the package that go from the user to the internet pass through your interface and this package
can be monitored with Wireshark.
So in your terminal type Wireshark and wait a few seconds and then go up here and click Capture and
select the interface you have created.
In my case, is this one right here called fake and press start.
And now you can listen to all the wireless traffic on fake interface.
So have fun and thanks for watching.